Clean workshop design and installation company decoration planning construction plan

Nowadays, many enterprises not only innovate products from the production process, but also consider improving the production environment of products to improve product quality and stability. Therefore, the clean and clean workshop has become the choice of more and more enterprises. So what are the elegant decoration of clean workshop? The following Shanghai SAREN Sanren will tell you about the guidelines to abide by the decoration planning and construction plan of clean workshop engineering company.

First, the construction criteria of clean and dust-free workshops

Clean workshop design and installation is necessary to abide by three aspects of the criteria, namely: environmental assessment, health water,.

1. Environmental assessment: This is particularly important, if the site selection is not approved by the local environmental protection department environmental assessment, there is no environmental assessment statement, then everything is useless.

2. Water source: To ensure that the water supply in the workshop is sufficient, and the water source must meet the national drinking water standards.

3. Health: When selecting the site, it is necessary to select a region with good health conditions, such as low dust and bacteria in the atmosphere, no harmful gases, and a good natural environment. And the area to flat terrain, convenient transportation, water, electricity, gas and other supporting equipment.

senond. Planning guidelines for clean and dust-free workshops

The same as the construction of the purification workshop, its planning should also abide by three aspects of the guidelines, namely: process, economy, safety and environmental protection.

1. Process: The entire placement of the purification workshop is necessary to meet the requirements of the production process, specifically, the process flow should be smooth. Whether it is the upper process or the next process, the transport distance between the two should be short, and roundabout and round-trip transport should be prevented as far as possible.

Since fire prevention is particularly important, all SAREN Sanren Xiaobian will add some norms on fire prevention planning:

1. The fire resistance rating of the workshop shall not be lower than 2.

2. The number of safety exits in each fire protection zone or clean zone of the production layer shall be ≥2.

3. The roof, siding and sandwich data of the clean room should be non-incinerator, and organic matching data should not be selected: the fire resistance rating of the ceiling and siding should be ≥0.4h, and the fire resistance rating of the evacuation corridor ceiling should be ≥1h.

4. The allowable construction area of the fire protection zone: the single-storey plant should be 3000 square meters, and the multi-storey plant should be 2000 square meters.

5. The shaft wall of the skill shaft shall be non-incinerator, and the fire resistance limit shall be ≥1h; The fire resistance limit of the inspection door on the shaft wall is ≥0.6h.

2. Safety and environmental protection: The planning of the purification workshop should also pay attention to fire safety and meet the requirements of environmental protection. To meet the fire safety equipment, decorative building materials should also be environmentally friendly. The layout of the workshop should not only facilitate the connection of each production link, but also facilitate the health control of the processing process, and prevent the occurrence of pollution in the production process.

3. Economy: Under the premise of meeting the process requirements, the planning of the purification workshop should pay attention to economy and have a high cost performance. It is advocated to adopt a relocation plan with minimum traffic volume and make full use of the existing site area. In addition, the auxiliary production shop and service department should be organized around the basic production shop.